X
Product was successfully added to your shopping cart.

Continue Shopping

Altronix Power Device

7 Item(s)

per page
  1. Altronix Parts

    Products and parts from Altronix.
  2. Altronix ALTV2416 Power Supply

    The Altronix ALTV2416 Power Supply provides 24 VAC or 28 VAC distributed via sixteen (16) fuse or PTC protected outputs for powering CCTV Cameras, heaters and other video accessories. It has a supply current of 24 VAC @ 8 amp (200VA) or 28 VAC @ 7 amp (200VA). Main fuse is rated @ 10 amp/250V. It has a power ON/OFF switch. ALTV2416 Power Supply's ease of installation saves time and eliminates costly labor.
  3. Altronix HubWay

    HubWay Video Balun/Combiner to be used with any HubWay and HubSat UTP Transceiver Hub routes Video/Data and Power from the Altronix HubWay or HubSat units for either fixed or PTZ cameras.
  4. Altronix AL1012ULACM Power Supply-Charger

    The AL1012ULACM Power Supply-Charger converts an 115 VAC 60Hz input into eight (8) independently controlled 12VDC Fail-Safe and/or Fail-Secure outputs with a total of 10 amp continuous supply current. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an access control system, card reader, keypad, push button, PIR, etc. These units will route power to a variety of access control hardware devices including mag locks, electric strikes, magnetic door holders, etc. The outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables emergency egress, alarm monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.
  5. Altronix AL300ULPD4 Power Supply-Charger

    Altronix AL300ULPD4 Power Supply-Charger multi-agency approved multi-output power supply/chargers convert a 115 VAC/60Hz input to four (4) or eight (8) class 2-rated 12VDC or 24VDC power limited outputs. AL300ULPD4 Power Supply-Charger has a 2.5 amp supply current and electronically regulated outputs. Maximum charge current is .7 amp. It automatically switches over to stand-by battery when AC fails (zero voltage drop). Gray enclosure.
  6. Altronix AL300ULXR Power Supply-Charger

    Altronix AL300ULXR Power Supply-Charger converts a 115 VAC/60Hz input into one (1) class 2-rated 12VDC or 24VDC power limited output. It has a 2.5 amp supply current and class 2-rated power limited output. Maximum charge current is .7 amp. It automatically switches over to stand-by battery when AC fails (zero voltage drop).
  7. Altronix eFlow3N Power Device

    The Altronix eFlow3N is a power supply/charger which converts a 115 VAC/60Hz input into a single 12VDC or 24VDC Class 2 Rated power limited output.

7 Item(s)

per page